Reply To: Lyons super rear drum puller Rev A

[Jim Chase]

If as Rick notes you have threads on the end of the drum, that could make for another variation on the pipe flange idea that would not require pulling on the studs. An unthreaded pipe flange could be machined and threaded to screw directly onto the drum hub center thread, then another matching flange cap placed on the axle+axle nut and four bolts put through the four holes in the flanges. Actually less machining, except for the inside thread part that is beyond my (low) skill level. Keeping the axle nut on means everything is trapped and nothing will come flying off. Didn’t know anyone was in the business of building new pullers, sounds like a good place to start.

Jim