Series 80 Bumper Bracket Springs Help Needed

Home Page › Forums › Chassis › Series 80 Bumper Bracket Springs Help Needed

  • This topic has 1 reply, 2 voices, and was last updated 17 years ago by
    Author nameAuthor names are only available to PAS members.
    .
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • November 8, 2007 at 4:06 pm #389923
    Author nameAuthor names are only available to PAS members.

    Attempts are being made to reproduce a front bumper for a Series 80. We have the recast brackets (the pattern is available if someone else wants to cast these) and tube bumper but we are in need of correct coil springs for the bolt that attaches the brackets to the frame. Tried local shops, McMaster and the like but to no avail. Has anyone made any or have a source for them.? Perhaps someone has two originals they would sell? Can anyone help? I can send measurements and photo of an original if that would help. Thanks, Tom

    November 22, 2007 at 9:40 pm #393312
    Author nameAuthor names are only available to PAS members.

    Do you know if the series 80 brackets are the same as the series 81?
    I need an entire front bumper assembly for my ’28 sedan. Thank you, dick little

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.