Stromberg uu2 carb rebuild

Home Page › Forums › Engine › Stromberg uu2 carb rebuild

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • October 10, 2012 at 2:16 pm #390706
    Author nameAuthor names are only available to PAS members.

    I am in the process of overhauling my Stromberg UU2 Carb from my 1930, Model A sedan. I have the body gasket as well as the various small paper and cork gaskets but would appreciate and insights regarding Overhauling a UU2, cut way drawing as well as the specific size of just where the various gaskets go. I have not disassembled the carb yet but will start it next week. Any thoughts appreciated. Thanks.

    October 10, 2012 at 5:23 pm #395515
    Author nameAuthor names are only available to PAS members.

    I’ve gone through the UU2 on my ’29 so if you need help let me know.

    The gasket places are pretty self explanatory once you get into the carb.

    The float mount tang under the float cover can be very fragile so just be careful when you pull the float cover.

    Be gentle.

    Also, your venturies may be brittle as well but John Cislak sells replacements.

    He has quite a few replacement parts for the UU2.

    October 11, 2012 at 8:44 pm #395519
    Author nameAuthor names are only available to PAS members.

    Syd, they are not too difficult. Just take your time and be sure not to break anything. You must remove ALL the brass plugs in the ENTIRE carb so you can clean everything well. Ed

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.