Brass levers for 29 DC

Home Page › Forums › Body › Brass levers for 29 DC

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • October 14, 2014 at 6:34 am #391142
    Author nameAuthor names are only available to PAS members.

    Hi all,

    I am in need of the brass levers for the dash. The base’s are beautiful but the levers are broken off. Obviously, became too brittle over the years.

    Second question: how do you get these off. Not sure if they are just rusted but when I turne the nut on the back side the entire center piece spins. Cant seem to find where to secure it to loosen the bolt. Seems so simple but its a pain. Don’t want to break anything. Any tips.

    October 14, 2014 at 7:17 am #397819
    Author nameAuthor names are only available to PAS members.

    Richard, the long rod seems to get tight at the firewall mount and not at the knob end, with some lube and time you can get them loose. Be careful not to ruin the rear mount as they’re not available as a replacement part.The lever was cast to the rod, you will be breaking this off the rod and reuse the rod with a new casting. You can get replacement castings then silver solder them to the rods. First call would be to Dave Murray. If he is out of stock, I may have a few. Karl

    October 14, 2014 at 8:22 pm #397824
    Author nameAuthor names are only available to PAS members.

    thank you Karl. :)

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.