rear brake actuator rods and brackets

Home Page › Forums › Chassis › rear brake actuator rods and brackets

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • December 5, 2016 at 3:13 pm #391905
    Author nameAuthor names are only available to PAS members.

    Hello Friends,

    1934 836a – I am missing the rear brake actuator rod and linkage for the drivers side. Does anybody have a picture of what the brackets look like? I might fab up my own but would like to see what it is supposed to look like.

    Any ideas or advice is welcome!

    I can also trade for the parts if someone has them. I have a good Stewart Warner fuel pump core – just needs a diaphragm, and a good set of chrome brackets for mounting the lights and horns on the front grille. (for 1934 836)

    Thanks,

    Blaine

    925.325.8051

    December 6, 2016 at 3:40 pm #403537
    Author nameAuthor names are only available to PAS members.

    If the 836 is the same as 1935 845 I can take some pics this weekend.

    Jim

    December 7, 2016 at 12:44 pm #403539
    Author nameAuthor names are only available to PAS members.

    Hi Jim,

    Thanks so much for the kind offer – much appreciated. Even if they were not the same form the factory, I need an idea on how to proceed, so whatever will work is fine with me.

    – maybe a pic of your car as well???

    Thanks,

    Blaine

    [email protected]

    December 9, 2016 at 2:58 pm #403541
    Author nameAuthor names are only available to PAS members.

    Here are a few pics of mine showing the brake torque shaft going into the drivers side without bracketry, the U-bend of the shaft, and the bracket that is only on the passenger side of the rear axle.

    Hope this helps.

    Jim

    December 9, 2016 at 6:49 pm #403543
    Author nameAuthor names are only available to PAS members.

    That’s it Jim, just what I needed to see – thanks so much!!

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.