Coupler disks for generator to water pump.

Home Page › Forums › Engine › Coupler disks for generator to water pump.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 20, 2019 at 11:11 pm #392806
    Author nameAuthor names are only available to PAS members.

    I have a 1937 Pierce 8. For the third time in 25 years my couplers have failed. I have noticed that the thickness of the coupler should not be much more than 3/16 inch. ( I measured this very carefully with vernier calipers ) The total gap open to both disks being 3/8 in. I was told that the GM power steering disks would fit marvelously. They dont. They are way too thick. What to do? Help!

    I can fabricate a hard leather disk out of 10 – 13 ounce grade. That thick ness is about right per disk.

    October 21, 2019 at 12:10 am #411125
    Author nameAuthor names are only available to PAS members.

    I thought John Cislack has some of those discs.

    You might want to contact hims and see.

    October 21, 2019 at 8:44 am #411127
    Author nameAuthor names are only available to PAS members.

    I bought one for my 31 from John Cislak, I think it was around $20 or so and fit perfectly.

    October 21, 2019 at 2:32 pm #411129
    Author nameAuthor names are only available to PAS members.

    I thought Bob Sands had some also

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.