Fan support

Home Page › Forums › Engine › Fan support

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • February 10, 2020 at 10:02 am #392893
    Author nameAuthor names are only available to PAS members.

    I was looking at the fan support on my 836 and was wondering what the extra holes were on the mounting face.

    I first thought it was for a very coarse belt adjustment?

    Any clues?

    February 10, 2020 at 11:30 am #411847
    Author nameAuthor names are only available to PAS members.

    When I took mine apart that was all I could think of too.

    February 10, 2020 at 4:49 pm #411850
    Author nameAuthor names are only available to PAS members.

    I think that’s correct. It gives you more leeway in case you can’t locate the correct length. It may also be that the old belts used to stretch a lot over time and this would give you some take-up.

    Bill

    February 14, 2020 at 1:32 am #411854
    Author nameAuthor names are only available to PAS members.

    Every fan support mount I”ve seen has two sets of holes.. Maybe the V12 had a different spacing requirement?

    Greg

    “

    February 14, 2020 at 7:59 am #411861
    Author nameAuthor names are only available to PAS members.

    There ate three different casting numbers on all the brackets from 29-38 8 & 12. And they all seem to interchange without any issue. John and I have gone over them several times, never figured out why the different numbers or the extra holes. Unless the extra holes fit a Stude.

    February 29, 2020 at 3:46 pm #411961
    Author nameAuthor names are only available to PAS members.

    Here’s one from a ’29 AFAIK that has only four holes.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.