Throwout bearing carrier

Home Page › Forums › Engine › Throwout bearing carrier

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • November 21, 2022 at 8:20 am #471487
    Author nameAuthor names are only available to PAS members.

    So, I am trying to figure out how the throwout bearing carrier attaches to the clutch fork.

    It looks like almost an interference fit between the two arms of the T/O fork (white paint)

    I have the carrier on the wrong side (backwards) in this pic.

    November 22, 2022 at 11:10 am #471500
    Author nameAuthor names are only available to PAS members.

    It doesn’t attach to the forks, it’s pulled back and held onto the forks by a spring that attaches to the transmission and to the tab on the throw out bearing where the screw is. You can use the inspection cover to align the throw out bearing onto the forks and attach the spring if you only remove the transmission and not the bell housing.

    November 23, 2022 at 6:50 am #471502
    Author nameAuthor names are only available to PAS members.

    Billy,

     

    Thanks for the reply. After looking at the transmission, I figured it slid on the snout. I am good and thanks

     

    Bill

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.