Gas Tank Shroud on my ’31 Model 42 5P Sedan

[Author nameAuthor names are only available to PAS members.]

Hi, everyone,

I need to remove the sheet metal shroud that covers the gas tank on my ’31 Model 42 5P Sedan.  It appears that I need to remove the gas tank to have access to the screws that attach the shroud to the body.  Has anyone removed the shroud and can therefore confirm that the shroud is attached as I described?

Thanks,

Bill

[Author nameAuthor names are only available to PAS members.]

Bill, I have a 31 Model 42 Phaeton and I did remove the gas tank to remove the shroud.  I found that there were nails where the heads only held the shroud in place. I don’t know if that is standard or not.  I suppose if one pulled hard enough one could slide the shroud out but then you would have the problem of getting the shroud back in place and properly captured when you reinstalled it.  Removing the gas tank is a bit tricky but not hard.  You can unbolt the straps which hold the tank in place allowing the tank to sag a bit. That will allow you to get to the vent hose which I needed to remove to maneuver things around the exhaust. Once the vent hose is off, there are “pins” that hold the other ends of the straps in place.  Those can be pulled out and the tank will drop straight down.

Good luck,

Kirby

[Author nameAuthor names are only available to PAS members.]

Thanks for the help, Kirby

Bill

[Author]

Posts