rear brake actuator rods and brackets

[Author nameAuthor names are only available to PAS members.]

Hello Friends,

1934 836a – I am missing the rear brake actuator rod and linkage for the drivers side. Does anybody have a picture of what the brackets look like? I might fab up my own but would like to see what it is supposed to look like.

Any ideas or advice is welcome!

I can also trade for the parts if someone has them. I have a good Stewart Warner fuel pump core – just needs a diaphragm, and a good set of chrome brackets for mounting the lights and horns on the front grille. (for 1934 836)

Thanks,

Blaine

925.325.8051

[Author nameAuthor names are only available to PAS members.]

If the 836 is the same as 1935 845 I can take some pics this weekend.

Jim

[Author nameAuthor names are only available to PAS members.]

Hi Jim,

Thanks so much for the kind offer – much appreciated. Even if they were not the same form the factory, I need an idea on how to proceed, so whatever will work is fine with me.

– maybe a pic of your car as well???

Thanks,

Blaine

[email protected]

[Author nameAuthor names are only available to PAS members.]

Here are a few pics of mine showing the brake torque shaft going into the drivers side without bracketry, the U-bend of the shaft, and the bracket that is only on the passenger side of the rear axle.

Hope this helps.

Jim

[Author nameAuthor names are only available to PAS members.]

That’s it Jim, just what I needed to see – thanks so much!!

[Author]

Posts