Throwout bearing carrier

[Author nameAuthor names are only available to PAS members.]

So, I am trying to figure out how the throwout bearing carrier attaches to the clutch fork.

It looks like almost an interference fit between the two arms of the T/O fork (white paint)

I have the carrier on the wrong side (backwards) in this pic.

[Author nameAuthor names are only available to PAS members.]

It doesn’t attach to the forks, it’s pulled back and held onto the forks by a spring that attaches to the transmission and to the tab on the throw out bearing where the screw is. You can use the inspection cover to align the throw out bearing onto the forks and attach the spring if you only remove the transmission and not the bell housing.

[Author nameAuthor names are only available to PAS members.]

Billy,

 

Thanks for the reply. After looking at the transmission, I figured it slid on the snout. I am good and thanks

 

Bill

[Author]

Posts