rear end lub.

Home Page › Forums › General › rear end lub.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • January 1, 2016 at 7:58 pm #391523
    Author nameAuthor names are only available to PAS members.

    what lub. is used in the rear end of a 33 PA and where can i get it?

    January 2, 2016 at 6:43 pm #401150
    Author nameAuthor names are only available to PAS members.

    NAPA will have it available

    GL-1 NON-EP 90W

    January 2, 2016 at 9:48 pm #401153
    Author nameAuthor names are only available to PAS members.

    G’day Bill—Is the rear end Hypoid Bevel or Worm?

    January 3, 2016 at 9:46 am #401160
    Author nameAuthor names are only available to PAS members.

    Bill,

    If it is an 836 or a 1236, it will have a worm drive from the factory and have a bronze bull gear. If so, you MUST use a non-sulfur-bearing lubricant (not the typical rear end lube), so the bronze wheel does not get attacked. Not a problem for the 1242 and 1247 which are hypoid.

    Restoration Supply Co also has Lubriplate lubricants (below)

    http://www.restorationstuff.com/pdf/RestorationSupplyCompany.pdf

    January 3, 2016 at 10:05 am #412841
    Author nameAuthor names are only available to PAS members.

    The owner manual for the 836 lists the lubricant for the rear axle as

    “Special Lubricants” obtainable at all authorized Pierce Arrow Service Stations, particularly for the transmission, rear axle and steering gear.”

    Of course I am answering this as if it is for a 1933 not Model 33. If it is for a Model 33, forget all of the above.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.