1929 fan pulley rebuild

Home Page › Forums › Chassis › 1929 fan pulley rebuild

Tagged: 

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • May 4, 2023 at 1:29 pm #477281
    Author nameAuthor names are only available to PAS members.

    1929 fan pulley pump rebuild.
    Usually the fiber gear goes bad from sitting a long time or lack of lubrication. If the bushing and shaft aren’t worn out you can replace just the fiber gear after bead blasting or a good cleaning. Buick uses the same fiber gear and are still available. A photo of mine is attached.
    hope this information is useful.1929 Pulley pump

    May 9, 2023 at 6:47 am #477305
    Author nameAuthor names are only available to PAS members.

    What does this device do?

     

    May 9, 2023 at 10:48 am #477307
    Author nameAuthor names are only available to PAS members.

    The hub is an oil reservoir, the two gears are an oil pump the supplies oil to the shaft and bushing for the fan pulley assembly. A few ounces of motor oil into the hub when the slotted screw is removed. Pretty simple idea.

    May 11, 2023 at 12:38 pm #477312
    Author nameAuthor names are only available to PAS members.

    So I need to check mine 

     

    May 11, 2023 at 1:09 pm #477313
    Author nameAuthor names are only available to PAS members.

    If you haven’t, I would take it off clean it and see if it fiber gear is still in good condition. Good maintenance practice. Thanks, Andrew

    May 16, 2023 at 10:35 am #477326
    Author nameAuthor names are only available to PAS members.

    I guess Charley Chaplin was right!

    In earlier PA owners and service manuals you had “Your Man” oil the fan bearing, now he was replaced by modern (steam punk) “technology”.

    Does the oil matter?… 30W non detergent?

    Buick club for the gear?

    Thanks for the insight into my car. Todd

    May 16, 2023 at 4:20 pm #477328
    Author nameAuthor names are only available to PAS members.

    30W will work, I got a couple from the Buick guy. Perfect fit

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.