Reply To: 1935 P-A 845 project ongoing

[Author nameAuthor names are only available to PAS members.]

I’m trying to remove only the engine and leave the transmission in the car. We took all the bolts that connect the cylinder block to clutch housing off, but we cannot get the block separated from the clutch housing.

I was wondering, can there be any more bolts inside the clutch housing that is bolted to block, or is the transmission shaft/bearing holding the tranny so tightly to cylinder block?

I was hoping to leave the tranny in the car standing on the mounts that are located in the rear of the cylinder block (below firewall) .