1911 36 Block

Home Page › Forums › General › 1911 36 Block

Tagged: 

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 28, 2025 at 8:23 pm #481902
    Author nameAuthor names are only available to PAS members.

    Does anyone have a spare block?  have there been new castings over the years?   is there any available?

    Any patterns existing?

    I have two 1911 model 36’s. I am in need of some water jacket repairs, but i am preparing for worst case scenarios.   Also, with 6 pairs to look after i should have at least one extra pair in case of tradgedy!

    Thanks in advance,

     

    Jay

     

    610-416-7677

    December 30, 2025 at 10:18 am #481910
    Author nameAuthor names are only available to PAS members.

     

    Hi Jay,

    I have a 1919 Model 51 that had a very nasty crack in one of the jugs (apparently, a previous owner thought some epoxy and black enamel was the way to repair it).  The jug looked potentially unrepairable once the epoxy and corrosion were cleaned.  However, I had prior experience with Lock-n-Stitch in Turlock, CA and contacted them. (I would note that they have been acquired by Wartsila Marine and their old website is gone.  Phone number is (209) 632-2345)  They did a near-miraculous repair on the jug.  It wasn’t cheap, but compared to a new casting or even an old jug….

    Cracked Jug

    Repaired Jug

    December 31, 2025 at 5:36 pm #481935
    Author nameAuthor names are only available to PAS members.

    thank you very much for the response and information !

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.