new running boards

Home Page Forums General new running boards

Viewing 13 posts - 1 through 13 (of 13 total)
  • Author
    Posts
  • #391188

    Does anyone have a pair or running boards for a 29 phaeton. If not, is there a place that reproduces them?

    thanks for any help. Rick

    #398172

    Which part of the board do you need? New rubber covering is available most likely from Steele Rubber.The board itself is made of flat steel to which the rubber is cemented.

    #398177

    I found the trim and the rubber. I need the steel board itself.

    thanks, Rick

    #398184

    Rick,

    The metal board should be able to be fabricated.Is your original rusted out? If not too bad,it should be able to be repaired.

    #398190

    One could be repaired but the other is rusted out.

    #398196

    I believe a very good fabricator could make you a new one.

    #398217

    Runningboardrubber.com

    Makes the items in need

    #398219

    Roger,

    Thank you. Its hard to find somone who will make the shells. The mats seem to be no problem. thanks again. Rick

    #398220

    Contact the Henningsen Machine Shop in Salinas,California.Scott has a website so just Google the shop name.Scott can build a body so I believe

    he could fabricate a running board.

    #398221

    Cool! Thank you

    #398224

    Richard,

    Where did you find the trim? Are they repro? I can find aluminum but not stainless. Jim

    #398228

    Jim,

    L & L auto trim. Hope this helps. Rick

    http://www.runningboardmetaltrim.com/

    #398234

    Rick,

    They only list Aluminum trim. I’ll contact them tomorrow and make sure. Jim

Viewing 13 posts - 1 through 13 (of 13 total)
  • You must be logged in to reply to this topic.