window regulator channel

Home Page Forums Body window regulator channel

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
  • #391868

    Restoration of my 1930 Pierce-Arrow convertible sedan has proceeded slowly, but now I am ready to install the window frames, which were made several years ago.. Now I need the window regulator channels which attach to the bottoms of the frames. I will also need some flat stock, 1 inch wide, to spot weld to the side of the regulator channel and the bottom part of the window frame. See the photo below.

    I am wondering if anyone can suggest a possible supplier for these regulator channels or stock from which I can cut them. The cross section is shown in the attached drawing. Please let me know if you can suggest a source for this kind of window regulator channel stock. Thanks.


    I seem to remember that Model A Ford Tudor rear quarter ones can be adapted. Worked for me on 1929 Brougham rear quarter windows. Also I suggest Restoration Supply Co in California.

    Good luck



    Aircraft Spruce and Specialty sells 4130 strips

    .032 1 x 72 03-18120 $4.75 for 6′

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.